LED Pendulum Slim RGBW Tree

The LED Pendulum Slim RGBW Tree is a tube-shaped pendant light fixture with warm white and colored light for 24VDC supply. The connection to the Miniserver is via Loxone Tree technology.

Datasheet LED Pendulum Slim RGBW Tree

Mounting
Commissioning
Tree Communication and Voltage Drop
Inputs, Outputs, Properties
Safety Instructions
Documents

Mounting↑

Switch off the supply voltage before installation.

If necessary, shorten the connection cable to the desired length.

Mount the base plate to the ceiling. The canopy is later screwed onto the base plate.

Connect the power supply (orange/white wire) and Tree communication wires (green/white wire).

Then screw the lamp onto the base plate. Make sure that no wires are jammed.

Commissioning↑

For lights, a commissioning mode is active when the devices are supplied with power and have not yet been paired.
In this mode, the device indicates whether it has been connected correctly and, if the connection is successful, provides lighting until it has been paired.

This function is supported since Loxone Config 14.0.3.28, depending on the device firmware.

Then follow the pairing procedure on the Tree Interface.

Tree Communication and Voltage Drop↑

If the current flow on the GND line results in a voltage drop too high, this potential difference also affects the tree communication.
To solve this problem, split consumers of higher power over longer distances to several supply lines, or use a supply line with a higher cross-section, or a power supply close to the consumers.
For existing installations, doubling the cross-section of the GND line is often sufficient to eliminate the potential difference.

Actuators↑

Summary	Description	Value Range
Smart actuator RGBW	Smart actuator	∞

Diagnostic Inputs↑

Summary	Description	Unit	Value Range
Online Status LED Pendulum Slim RGBW Tree	Indicates whether the device can be reached by the Miniserver. Diagnostics for Air devices Diagnostics for Tree devices Diagnostics for Extensions	Digital	0/1

Properties↑

Summary	Description	Default Value
Monitor online status	When selected, you will be notified via System Status or the Mailer if the device is no longer available or goes offline.	-
Serial number	Specifies the serial number of the device. For Extensions: Enter 'Auto' to automatically pair an extension with unknown serial number. This can only be used if there is only one Extension of the same type. Save into the Miniserver, in order to pair the Extension. Afterwards the program must be loaded from the Miniserver to transfer the actual serial number of the Extension into the program.	-
Device type	Tree device type	-
Actuator Type	Use device with Standard Actuator(s) or Smart Actuator(s) Smart Actuators support dynamic fade times and can only be used with the Lighting Controller.	-

Safety Instructions↑

The installation must be carried out by a qualified technician in accordance with all applicable regulations.

Ensure that the device is protected from water.

Documents↑